DACOverreview

Topping Centaurus

Holo Audio's resistor ladder in a Topping box: record numbers for R2R, a launch tripped up by firmware, and no agreement on whether it has a sound.

24 sourcesUpdated
$849Typical US price

Score aggregates reviewer opinions across topics.

Check price on Amazon
As an Amazon Associate, we earn from qualifying purchases.
Topping Centaurus

The short version

What to know.

A $849 line-level R2R DAC that pairs Holo Audio's resistor-ladder module with Topping's electronics and feature set. Sources agree on the hardware basics: it is very quiet, it measures near the top of what R2R DACs achieve in its default mode, and it packs more in than its rivals — six digital inputs, RCA and XLR outputs with selectable level, a choice of NOS and oversampling modes, a ten-band parametric EQ, Bluetooth, trigger ports and a remote. They also agree on the small irritations: no volume knob, front touch buttons that are hard to see, and EQ software that runs only on Windows. The sound is where they part. Most reviewers and owners hear a smoother, more natural presentation than Topping's chip-based DACs and want it for that; a measurement-minded group hears a transparent DAC with no character at all; a third finds it flatter and less resolving than similarly priced rivals. The launch firmware made things worse: one lab measured large faults in NOS mode with CD-rate music and at 8× and 16× oversampling. Topping has since released updates and owners report the faults fixed, but no lab has re-tested it. A handful of owners report failed updates, glitches or dead units. Whether it is good value depends on which of those groups you belong to.

About this product

A line-level DAC with a digital volume control and no headphone output — it needs a headphone amp, an integrated amp or powered speakers. It uses the same Holo Audio R2R module as the Holo Audio Cyan 2, with Topping's own power supply, output stage and firmware. Not the Topping D90 III Discrete, which is a 1-bit design.

The Centaurus is the first resistor-ladder DAC from Topping, a company that made its name with chip-based converters and chart-topping measurements. The ladder is not Topping's own: it is the R2R module Holo Audio builds for its Cyan 2, set in a Topping chassis with Topping's switching power supply and output stage, a colour display, Bluetooth, a remote and a ten-band parametric EQ. It was announced in December 2024 at $799, repriced to $999 within a day, and now sells for about $849.

It is a line-level DAC with a digital volume control, so it needs a headphone amp, an integrated amp or powered speakers after it. On the bench it posted some of the best figures any R2R DAC has managed. Then a second lab found that several of its modes misbehaved, and listeners have never settled whether the ladder gives it a sound of its own.

A good fit for

  • Listeners who want to try R2R without giving up clean measurements, a display, a remote or EQ
  • People who use software upsampling such as HQPlayer and want a NOS DAC to feed
  • Systems with a good headphone amp or powered speakers that need a DAC with volume control and several inputs
  • Anyone who liked the Holo Audio Cyan 2 but wanted built-in oversampling and input switching

Think twice if

  • You buy on measurements or price alone — chip-based DACs measure as well or better for less
  • You want the most detail and dynamics for the money; several reviewers preferred rivals at the price
  • You need a headphone output, analog inputs or a volume knob
  • You use a Mac or Linux and want the built-in EQ — its setup app is Windows-only
  • You would rather not update firmware or deal with the occasional glitch owners report

The reviewer consensus

Agreement &
disagreement.

2 / 6topics divide opinion
4 Mostly agree2 Divided opinions

Common ground5

  • Very low noise — a black background, confirmed by two independent test benches
  • In its default mode it measures among the cleanest R2R DACs at any price
  • More features than its R2R rivals: selectable inputs, NOS and oversampling, a 10-band parametric EQ, Bluetooth, trigger ports and a remote

Points of contention3

  • Sound: a smoother, more natural R2R character vs a transparent DAC with no sound of its own vs flatter and less resolving than rivals
  • Value: a strong buy against the pricier Cyan 2 vs only worth it if you specifically want R2R vs not worth $849–999 at all
  • Whether firmware has fixed the NOS and high-oversampling faults measured in March 2025 — owners say yes, no lab has re-tested

A closer listen.

6 topics · 2 divided
Left: criticalRight: positiveTighter lines: more agreement

Transparency

Leans positiveDivided opinions
Reviewer sentiment21 supporting sources
CriticalNeutralPositive

Band: opinion spread · Dot: weighted average

Sources split three ways. The largest group hears an R2R character — smoother, fuller in the midrange and more natural than Topping's chip-based DACs, though not as warm as older ladder designs — and counts that as the reason to buy it. A second group, anchored by the measurements, finds a transparent DAC that sounds like any other competent one once levels are matched. A third finds it held back: either by the mode faults measured on the launch firmware, or because rivals at the price sounded livelier, deeper or more resolving. Several in every group say resolution is not its strong point, and reviewers disagree about NOS versus oversampling: NOS rolls off the top octave, oversampling restores it.

Measured

Audio Science Review measured SINAD of about 112–114 dB from the XLR outputs (3.94 V) and 111–113 dB from RCA, with every harmonic below −120 dB — far cleaner than most R2R DACs — but intermodulation distortion at mid levels 20–25 dB worse than the best chip DACs, and no filter setting flat to 20 kHz (about −0.5 dB at 18 kHz in the default mode, about −1 dB in NOS). GoldenSound's bench, which swapped the same Holo module between a Centaurus and a Cyan 2, found the two nearly identical in the default mode at 4 V; on the March 2025 firmware it also found NOS mode about 20 dB worse with 44.1 kHz music and the channels out of phase, 8× and 16× oversampling adding distortion and jitter, and the 5 V output setting measuring worse. In ASR's reader poll (359 votes) 21% rated it great, 48.5% fine, 22% not terrible and 8% poor.

vs. listeners — Two things stay unresolved. First, the firmware: Topping issued updates through 2025 and owners report the NOS and oversampling faults gone — one re-test with a sound card on firmware 0.48 found every mode normal apart from minor deterioration at 16× — but no lab has measured it again, so the fix rests on owner evidence. Second, the listening split: the bench says distortion sits below audibility in the default mode, yet most reviewers describe a distinct character. The measurable candidates are small — a treble droop of half a decibel to a decibel, more in NOS mode — and the reviewer who compared it level-matched through a switch box against several other DACs heard no difference at all.

Where it splits
A real R2R character — smoother and more natural than Topping's other DACs, and better for it58%

“When it comes to timbre the Centaurus is more organic than most chip-based DACs I’ve heard but less coloured than other usual-suspect R2Rs.”

Rudolfs · Headfonia
Held back — faulty NOS and high-oversampling modes at launch, or flatter and less resolving than rivals22%

“unfortunately suffers from some major issues if you do anything but keep it in ‘best OS’ mode”

Cameron Oatley (GoldenSound) · Headphones.com
Transparent — distortion below audibility, and no sound of its own in a matched comparison20%

“Fortunately, distortion levels are likely still well below audibility, sans the rolled off highs that may be audible to younger folks.”

Amir Majidimehr · Audio Science Review
Link to this topic

The hardware

Specifications.

Checked

Design

Form factor
Desktop
DAC
Fully-balanced 8-channel R2R
PCM
768 kHz / 32-bit
DSD
DSD512

Output

Signal-to-noise
130 dB
EQ
Parametric, 10 bands

Connection

Digital inputs
USB-B, I²S, Optical, Coaxial, AES/EBU, Bluetooth
Line outputs
RCA, XLRvariable (preamp)
Preamp output
Yes
Bluetooth
Bluetooth 5.1SBC, AAC, aptX, aptX HD, aptX Adaptive, LDAC
Power
Mains (internal PSU)

Physical

Dimensions
220 × 160 × 45 mm

Outputs run fixed or variable at XLR 4 V or 5 V and RCA 2 V or 2.5 V; optical, coaxial and AES top out at 192 kHz. Manufacturer-published figures, not measurements · from audiophonics.fr, apos.audio.

Follow the evidence

Sources 24

1–6 of 24 sources

Read with context

Limitations & method.

As of

What to keep in mind 6

  1. A read of where reviewers and owners land as of November 2026. Prices have moved since launch — $799 for a day, $999 list, about $849 now — and newer R2R rivals keep arriving.

  2. Most professional reviews were written in the first few months, before Topping's later firmware. Owners report that the NOS and oversampling faults were fixed, but no lab has measured it again, so check the firmware version on any unit you buy.

Where to buy Product & retailer links

As an Amazon Associate, we earn from qualifying purchases.