Band: opinion spread · Dot: weighted average
The clearest point of agreement. Reviewers drove 150 Ω earbuds, Sennheiser HD 600 and HD 660S2, Beyerdynamic DT 900 Pro X and planar headphones such as the Audeze LCD-X and HiFiMAN Sundara to full listening levels, nearly always from the 4.4 mm balanced output and often on high gain. The caveats are consistent too: the 3.5 mm output has less than a third of the balanced power, low gain cuts it to about a quarter again, and the hardest loads are out of reach. One Amazon owner needed 80–90 of 100 on high gain for quiet tracks on a HiFiMAN Edition XS.
“The M1 Plus is not a DAP that’s lacking in output.”
Thomas, Headfonics
“Obviously, if you want to drive cans like Sennheiser flagship, you’ll have to go high-gain and balanced.”
NanoTechnos, Headfonia
“The maximum driving power, especially from the balanced output is plenty for full-sized headphones, at least the ones I tested, but the power is not sufficient for the likes of the HIFIMAN He1000 Unveiled.”
George Dobrescu, Audiophile-Heaven
Measured
No independent bench has measured the output. Shanling rates it at 195 mW into 32 Ω from the 3.5 mm output and 661 mW into 32 Ω from the 4.4 mm output on high gain, falling to 47 mW and 187 mW on low gain, with output impedance of 0.6 Ω and 1.2 Ω. Reviewers' volume settings give a rough check: AndyAudioVault reached normal listening level with a 300 Ω Sennheiser HD 600 at 50–54 of 100, and Play 32-bit with a HiFiMAN Edition XS at 50–55 % on high gain.
